HACO GROUP

Products Gallery

For Members/Agents

For Sanitary Fumishings

	Our Supports
	Useful Information
	FAQ

Inquiry Desk

REGISTER

SIGN IN

HACO SERVICES

1.	How to solve the problem of in stable temperature for Single-Lever Mixer?
2.	My house’s got less flow rate when using shower?
3.	I want to change the new faucet for basin but my bathroom has only 1 supply pipe while the faucet has 2 rigid tubes. How can I install it?
4.	The divertor on my faucet was stiff and let the water ran from both bath and shower outlet. Please give my suggestion to fix this problem.
5.	I have just renovated my bathroom but the water flow less from the faucet. How can I correct this problem?
6.	I found the problem about my faucet, which use for my bath. The problem was I can not switch the water form the bath outlet to shower outlet. To let the water run form shower, I have to press the button on the faucet by my finger all time. If my finger did not press that button, the water returned to bath outlet again. How can I do to correct this problem?

	How to solve the problem of in stable temperature for Single-Lever Mixer?
	- Solve the pumbling system. - Check pressure balance.

	My house’s got less flow rate when using shower?
	- Check if there is any dirty inside the shower or pipeline. - Adjust the flow rate.

	I want to change the new faucet for basin but my bathroom has only 1 supply pipe while the faucet has 2 rigid tubes. How can I install it?
	Connect T-connector with water pipe. Then connect 2 Stop Valve with 2 open sides of T-connector. You can insert the 2 rigid tubes on the Stop Valve.

	The divertor on my faucet was stiff and let the water ran from both bath and shower outlet. Please give my suggestion to fix this problem.
	The problem occurred because there were deposits on the divertor spindle. To fix this problem, only clean and regrease the divertor.

	I have just renovated my bathroom but the water flow less from the faucet. How can I correct this problem?
	There are 2 causes of problem include: Dirt deposit at valve inside the faucet. To correct the problem, only take out and clean the valve. If you already clean the valve but the problem still occurs, check your pump. It may not adequately supply.

	I found the problem about my faucet, which use for my bath. The problem was I can not switch the water form the bath outlet to shower outlet. To let the water run form shower, I have to press the button on the faucet by my finger all time. If my finger did not press that button, the water returned to bath outlet again. How can I do to correct this problem?
	The button on the faucet is divertor. It is used for switch the water from bath to shower outlet. It needs adequate flow pressure to stable it (at least 0.2 bar), when you press on it. In this case you have to increase water pressure to correct the problem.